Quests out there

[ken hendry]

I have been following the thread about Quests but do not know where to find
it. Who makes it? TIA
                                                    Ken
----- Original Message -----
From: "Henderson,Eric" <Eric.Henderson at gartner.com>
To: <discussion at nsrca.org>
Sent: Monday, December 15, 2003 5:49 PM
Subject: Quests out there


yeah, I'm still on my "quest", but not alone. Apart from the traffic on this
list, I ran into a notable designer/ builder who had one, broke it doing low
Knife-edges, Bought another and built that. The guys at his club liked them
so much that he ordered 12, yup!, that's twelve. He is now doing a lot of
ARF'ing of Quests for folks.

Some notes from our data swap.

1. 2-c's make it tail heavy, Put servos in middle (Not in tail)
2. YS 1.10 is the best motor for it
3. Works just fine with hard wood bearers.
4. Quieter with Hydemount.
5. There is a 1.10 ARI mount
6. Tail-wheel wire breaks - use alternative name brand, e.g. DuBro.

Regards,

Eric.


============# To be removed from this list, send a message to
# discussion-request at nsrca.org
# and put leave discussion on the first line of the body.
#


=====================================
# To be removed from this list, send a message to 
# discussion-request at nsrca.org
# and put leave discussion on the first line of the body.
#