YS 140 problem

Bob Kane getterflash at yahoo.com
Thu Jul 14 18:17:51 AKDT 2005


One more question, did you take the carb off or apart?
There is a gasket between the carb body and packplate
that will fit backwards and cause problems.

--- Bob Kane <getterflash at yahoo.com> wrote:

> Wow, that is a big prop . . . .
> 
> Anyway, check the throttle stop screw, you should be
> able to close the throttle barrel with the servo.
> The
> stop screw is next to the intake opening. 
> 
> 
> The low end needle should be out about 1 turn from
> closed. It is an air bleed, so in is richer, out is
> leaner.
> 
> --- "Daniel J. Hamlett" <d77hamlett at comcast.net>
> wrote:
> 
> > The engine is a sport.  It has less than 40oz
> > through it.  I am running  
> > the 1.40, NHP 5/8th header and ES carbon 5/8th
> inlet
> > pipe.  Sorry I 
> > forgot to add this on the original post.
> > 
> > Bob Kane wrote:
> > 
> > >Which 140?  FZ, L, DZ, Sport?  I assume it must
> be
> > a
> > >DZ swinging a 17X10?
> > >
> > >--- "Daniel J. Hamlett" <d77hamlett at comcast.net>
> > >wrote:
> > >
> > >  
> > >
> > >>I know that in the past there has been a post on
> > the
> > >>following topic but 
> > >>I don't have it.  Something about having to
> drill
> > >>out the spray bar ???
> > >>
> > >>I have a YS 140 that I can't get to idle down to
> > >>2200.  The lowers that 
> > >>I can get it is to about 2750-2800.  I know that
> > >>this is way too high.  
> > >>I am running a Mezlick 17X10 prop and S+W 20/20
> > >>fuel.
> > >>
> > >>Any help on this would be appreciated.
> > >>
> > >>Thank you in advance and good luck to all at the
> > >>NATS.
> > >>
> > >>Dan
> > >>
> > >>    
> > >>
> > >
> > >
> > >Bob Kane
> > >getterflash at yahoo.com
> > >
> >
> >__________________________________________________
> > >Do You Yahoo!?
> > >Tired of spam?  Yahoo! Mail has the best spam
> > protection around 
> > >http://mail.yahoo.com 
> > >=================================================
> > >To access the email archives for this list, go to
> > >http://lists.f3a.us/pipermail/nsrca-discussion/
> > >To be removed from this list, go to
> > http://www.nsrca.org/discussionA.htm
> > >and follow the instructions.
> > >
> > >List members email returned for mailbox full will
> > be removed from the list.
> > >
> > >
> > >  
> > >
> > 
> 
> 
> Bob Kane
> getterflash at yahoo.com
> 
> 
> 		
> ____________________________________________________
> Start your day with Yahoo! - make it your home page 
> http://www.yahoo.com/r/hs 
>  
> =================================================
> To access the email archives for this list, go to
> http://lists.f3a.us/pipermail/nsrca-discussion/
> To be removed from this list, go to
> http://www.nsrca.org/discussionA.htm
> and follow the instructions.
> 
> List members email returned for mailbox full will be
> removed from the list.
> 
> 


Bob Kane
getterflash at yahoo.com


		
____________________________________________________
Start your day with Yahoo! - make it your home page 
http://www.yahoo.com/r/hs 
 
=================================================
To access the email archives for this list, go to
http://lists.f3a.us/pipermail/nsrca-discussion/
To be removed from this list, go to http://www.nsrca.org/discussionA.htm
and follow the instructions.

List members email returned for mailbox full will be removed from the list.



More information about the NSRCA-discussion mailing list