[NSRCA-discussion] interference

Keith Black tkeithblack at gmail.com
Mon Feb 19 15:27:22 AKST 2007


Jerry,

I've personally had no problem with steel pull-pull cables, however, I've also been careful to keep the antenna away from the pull-pull cables by several inches.

Do you understand what occurred with your last incident?  I've heard of people losing  their replacement plane because they didn't realize they had either a bad TX or bad RX and they used them in the replacement plane. Therefore, if I were you I'd focus on making 100% SURE that none of the components used before (that you plan to use again, including TX) are faulty. 

I'm not quite this hard core, but Earl Haury once told me that when he has a crash he takes the RX home and introduces it to his hammer. This would certainly prevent any problems with the RX (either causing the crash or caused by the crash) from downing any future planes. 

Keith Black
  ----- Original Message ----- 
  From: jfgreen 
  To: 'NSRCA Mailing List' 
  Sent: Monday, February 19, 2007 5:46 PM
  Subject: [NSRCA-discussion] interference


  In an effort to avoid turning my new pattern ship into a dirt seeking comet similar to my last Oly, I’ve been researching some possible causes,  I recently read from one source that one would or could have interference problems if when using steel pull-pull cables and installing the antenna parallel to them inside the fuse.  I have seen a number of AC at contests w/this configuration that seem to have no interference problems.  Your  experience, thoughts please.  THX - Jerry

   



  --
  No virus found in this outgoing message.
  Checked by AVG Free Edition.
  Version: 7.1.412 / Virus Database: 268.18.3/693 - Release Date: 2/19/2007




------------------------------------------------------------------------------


  _______________________________________________
  NSRCA-discussion mailing list
  NSRCA-discussion at lists.nsrca.org
  http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.nsrca.org/pipermail/nsrca-discussion/attachments/20070220/a24214e8/attachment.html 


More information about the NSRCA-discussion mailing list