<br><font size=2 face="sans-serif">There's no special worries for using Econocote on foam wings. &nbsp;Since standard covering procedure is to keep your iron at the lowest setting that will activate the adhesive and provide minimum shrinkage, Econocote should be theoretically safter than Monocote. HOWEVER, my experience with the stuff has lead me to the conclusion to only use it if I have to. &nbsp;I think it sticks worse than monocote and the adhesive lets go with less wear (and expecially if fuel gets on a seam). &nbsp;It is thinner, and shows surface imperfections more and is less opaque. &nbsp;It's overall shrink is less than monocote so is more difficult going around compound curves.</font>
<br><font size=2 face="sans-serif">&nbsp; I would guess that your adhesion problems are not universal. &nbsp;I mean, they are in certain spots. &nbsp;Balsarite the critical areas (around the perimeters) and try again. &nbsp;If, worst case, the covering only sticks in these areas, the finish can still be made to look good with a heat gun.</font>
<br>
<br><font size=2 face="sans-serif">--Lance</font>
<br>
<br>
<br>
<br>
<table width=100%>
<tr valign=top>
<td>
<td><font size=1 face="sans-serif"><b>Paul Reed &lt;paul@judco.net&gt;</b></font>
<br><font size=1 face="sans-serif">Sent by: discussion-request@nsrca.org</font>
<p><font size=1 face="sans-serif">02/13/2003 12:24 PM</font>
<br><font size=1 face="sans-serif">Please respond to discussion</font>
<br>
<td><font size=1 face="Arial">&nbsp; &nbsp; &nbsp; &nbsp; </font>
<br><font size=1 face="sans-serif">&nbsp; &nbsp; &nbsp; &nbsp; To: &nbsp; &nbsp; &nbsp; &nbsp;discussion@nsrca.org</font>
<br><font size=1 face="sans-serif">&nbsp; &nbsp; &nbsp; &nbsp; cc: &nbsp; &nbsp; &nbsp; &nbsp;</font>
<br><font size=1 face="sans-serif">&nbsp; &nbsp; &nbsp; &nbsp; Subject: &nbsp; &nbsp; &nbsp; &nbsp;EconoKote vs. MonoKote</font></table>
<br>
<br>
<br><font size=2 face="Courier New">Does anyone out there have any experience using EconoKote for foam core<br>
wings? My wing cores are honeycombed and I am having trouble with Monokote.<br>
The MonoKote especially the white is not adhering well to the balsa even<br>
though the surface has been cleaned thoroughly with compressed air and a<br>
tack rag. Your advice and experience will be appreciated.<br>
<br>
Regards,<br>
Paul Reed<br>
Quality Coordinator<br>
<br>
=====================================<br>
# To be removed from this list, send a message to <br>
# discussion-request@nsrca.org<br>
# and put leave discussion on the first line of the body.<br>
#<br>
<br>
<br>
</font>
<br>
<br>