<HTML><FONT FACE=arial,helvetica><FONT SIZE=2 FAMILY="SANSSERIF" FACE="Arial" LANG="0">In a message dated 4/3/2003 8:26:36 PM Eastern Standard Time, kerlock@attbi.com writes:<BR>
<BR>
<BR>
<BLOCKQUOTE TYPE=CITE style="BORDER-LEFT: #0000ff 2px solid; MARGIN-LEFT: 5px; MARGIN-RIGHT: 0px; PADDING-LEFT: 5px">Subj:<B>Re: OS 1.40 rear bearing replacement </B><BR>
Date:4/3/2003 8:26:36 PM Eastern Standard Time<BR>
From:<A HREF="mailto:kerlock@attbi.com">kerlock@attbi.com</A><BR>
Reply-to:<A HREF="mailto:discussion@nsrca.org">discussion@nsrca.org</A><BR>
To:<A HREF="mailto:discussion@nsrca.org">discussion@nsrca.org</A><BR>
<I>Sent from the Internet </I><BR>
<BR>
<BR>
<BR>
Hey Bryan,<BR>
<BR>
Just stick it in the oven at about 350, give it about 10-15 minutes, then<BR>
take it out...quickly...and smack it on a block of wood. The bearing will<BR>
fall out. Oh uh use a potholder or something =) Teehee.<BR>
<BR>
Then tap the front one out with a 1/2" dowel.<BR>
<BR>
When you put the new ones in, oil them, then heat the case again...and<BR>
freeze the bearings. Put the front bearing in first, then put the rear on<BR>
the crank and slap it in place.<BR>
<BR>
Then oil the crap out of the whole thing. it's just that easy.<BR>
<BR>
-Mike</BLOCKQUOTE><BR>
<BR>
<BR>
<BR>
Welcome back Mike,<BR>
<BR>
Good to see you back on the discussion board<BR>
<BR>
Matt</FONT></HTML>