<!DOCTYPE HTML PUBLIC "-//W3C//DTD HTML 4.0 Transitional//EN">
<HTML><HEAD>
<META http-equiv=Content-Type content="text/html; charset=iso-8859-1">
<META content="MSHTML 6.00.2800.1170" name=GENERATOR>
<STYLE></STYLE>
</HEAD>
<BODY bgColor=#ffffff>
<DIV><FONT face=Arial size=2>
<DIV><FONT face=Arial size=2>Cass, </FONT></DIV>
<DIV><FONT face=Arial size=2></FONT> </DIV>
<DIV><FONT face=Arial size=2> I have made a puller for the ST2300 and the
new MIntor 1.70 thrust washer. Very simple and effective. Go
to my photo section at this link for a clear shot of the puller or email me for
some photos.</FONT></DIV>
<DIV> </DIV>
<DIV><FONT face=Arial size=2>Drill two holes and tap for 6-32 bolts. Use a
piece of hard aluminum or steel about 1/8x3/4x1-1/2 and drill a hole
slightly larger then the crankshaft in the center. Drill 2 holes the same
distance apart as in the thrust washer large enough for the 6-32 to pass
through. Put the prop nut on the shaft set the puller over that then
insert 6-32 bolts. Tighten equally till washer pops off.</FONT></DIV>
<DIV><FONT face=Arial size=2></FONT> </DIV>
<DIV><FONT face=Arial size=2><A
href="http://www.rcuniverse.com/gallery/showphoto.php?photo=13229&papass=&sort=1&thecat=500">http://www.rcuniverse.com/gallery/showphoto.php?photo=13229&papass=&sort=1&thecat=500</A></FONT></DIV>
<DIV><FONT face=Arial size=2></FONT> </DIV>
<DIV><FONT face=Arial size=2>Wayne
Galligan</FONT></DIV></FONT></DIV></BODY></HTML>