<HTML><HEAD>
<META charset=US-ASCII http-equiv=Content-Type content="text/html; charset=US-ASCII">
<META content="MSHTML 6.00.2800.1400" name=GENERATOR></HEAD>
<BODY style="FONT-SIZE: 10pt; FONT-FAMILY: Arial; BACKGROUND-COLOR: #ffffff">
<DIV>
<DIV>
<DIV>Yes, I wwould like to see pictures. What did you use for your header extension?</DIV>
<DIV> </DIV>
<DIV>Jon Lowe</DIV>
<DIV> </DIV>
<DIV>In a message dated 6/1/2004 7:26:43 AM Central Standard Time, flyintexan@houston.rr.com writes:</DIV>
<BLOCKQUOTE style="PADDING-LEFT: 5px; MARGIN-LEFT: 5px; BORDER-LEFT: blue 2px solid">
<DIV><FONT face=Arial size=2>I have the same setup.... I extended the pipe length by another 1/2" (minimum) and I mounted the kline right against the needle valve (1/2" of tubing - total) inlet. It is very important that you keep the reg. close to the needle as well as try to isolate the reg. from hard vibration. I wrap the reg. in a rubber band. I am running 15%, APC 17x12, hatori header (and header extension).</FONT></DIV>
<DIV><FONT face=Arial size=2></FONT> </DIV>
<DIV><FONT face=Arial size=2>I still have a hiccup if I fly around a mid-throttle, but quite rare. It's getting hot here in TX so I've set the motor a bit rich and I'm turning approx. 8000 rpm on the ground. I can send pics of my setup later today if you like....</FONT></DIV>
<DIV><FONT face=Arial size=2></FONT> </DIV>
<DIV><FONT face=Arial size=2>(</FONT><A title=mailto:flyintexan@houston.rr.com href="mailto:flyintexan@houston.rr.com"><FONT face=Arial size=2>flyintexan@houston.rr.com</FONT></A><FONT face=Arial size=2>)</FONT></DIV>
<DIV><FONT face=Arial size=2></FONT> </DIV>
<DIV><FONT face=Arial size=2>Alot of guys around here in Dist 6 are running the same setup, but using a perry pump with good success as well.</FONT></DIV>
<DIV><FONT face=Arial size=2></FONT> </DIV>
<DIV><FONT face=Arial size=2></FONT> </DIV>
<DIV><FONT face=Arial size=2>Hope it helps,</FONT></DIV>
<DIV><FONT face=Arial size=2>Mark</FONT></DIV>
<DIV><FONT face=Arial size=2></FONT> </DIV>
<DIV><FONT face=Arial size=2>P.S. I had to lean the low needle until it would barely even start, then backed off (rich) a 1/4 turn. Now, I prime it, back flip, and its running.</FONT></DIV></BLOCKQUOTE></DIV>
<DIV></DIV></DIV>
<DIV> </DIV>
<DIV><FONT size=2 PTSIZE="10"><BR></FONT> </DIV></BODY></HTML>