<!DOCTYPE HTML PUBLIC "-//W3C//DTD HTML 3.2//EN">
<HTML>
<HEAD>
<META HTTP-EQUIV="Content-Type" CONTENT="text/html; charset=us-ascii">
<META NAME="Generator" CONTENT="MS Exchange Server version 6.5.7036.0">
<TITLE>Webra 1.45 problem</TITLE>
</HEAD>
<BODY>
<!-- Converted from text/rtf format -->
<P><FONT FACE="Comic Sans MS">I'm having a problem with my Webra 1.45 and I hope someone can help me out. I have a new Hydeout (thanks to the guys that gave me the control throw advice!) with a new Webra 1.45. Below are the details on the motor setup:</FONT></P>
<P><FONT FACE="Comic Sans MS">Prop: APC 17x2</FONT>
<BR><FONT FACE="Comic Sans MS">Fuel: Magnum #1</FONT>
<BR><FONT FACE="Comic Sans MS">Plug: OS #8</FONT>
<BR><FONT FACE="Comic Sans MS">Pipe: Greves</FONT>
<BR><FONT FACE="Comic Sans MS">Mount: Hyde type soft mount and nose ring</FONT>
<BR><FONT FACE="Comic Sans MS">Tank: Tetra 20oz, on CG of model</FONT>
<BR><FONT FACE="Comic Sans MS">I have about 2/3 of a gallon of fuel run through the motor, this Webra uses the regular carb with the high speed and low speed needles.</FONT></P>
<P><FONT FACE="Comic Sans MS">The problem is the motor dies when I roll from inverted to upright. This happens mostly after I have been at idle for a while. I'm flying the advanced routine and it dies during the roll out on the bunt and the bottom of the double I even the slow roll. I have never made it more than about 3 minutes into a flight.</FONT></P>
<P><FONT FACE="Comic Sans MS">It seems to run fine on the down lines at idle, like in the stall turns and the outside square loop.</FONT>
<BR><FONT FACE="Comic Sans MS">When it dies it sounds like someone pulled the fuel line off the engine, it just un winds. We tried leaning the low speed needle, replaced the tank internal fuel line to the clunk.</FONT></P>
<P><FONT FACE="Comic Sans MS">Any advice?</FONT>
</P>
<P><FONT FACE="Comic Sans MS">--Gordon</FONT>
</P>
</BODY>
</HTML>