<!DOCTYPE HTML PUBLIC "-//W3C//DTD HTML 4.0 Transitional//EN">
<HTML><HEAD>
<META http-equiv=Content-Type content="text/html; charset=US-ASCII">
<META content="MSHTML 6.00.2800.1400" name=GENERATOR></HEAD>
<BODY id=role_body style="FONT-SIZE: 10pt; COLOR: #8000ff; FONT-FAMILY: Arial"
bottomMargin=7 leftMargin=7 topMargin=7 rightMargin=7><FONT id=role_document
face=Arial color=#8000ff size=2>
<DIV>
<DIV>In a message dated 5/24/2005 7:47:20 AM Central Daylight Time,
ed_alt@hotmail.com writes:</DIV>
<BLOCKQUOTE
style="PADDING-LEFT: 5px; MARGIN-LEFT: 5px; BORDER-LEFT: blue 2px solid"><FONT
style="BACKGROUND-COLOR: transparent" face=Arial color=#000000 size=2>
<DIV>I've got a little bit of overspray to remove and need some advice.
It's PPG concept, with basically a very, very light dusting of yellow
over white. It's only visible in good light and you can feel the
roughness where the overspray is. </DIV>
<DIV> </DIV>
<DIV>It really looks like I can just rub it out, but the question I have is
with what? I don't want to clear coat it afterwards, so I'm looking for
a way to rub it out and retain the full gloss of the finish. Also, I
still want to put some graphics in the area, so I don't want to use any
wax coat if at all possible. The yellow is about 3 days into curing
right now, the white is about 6 days.</DIV>
<DIV> </DIV>
<DIV>TIA!</DIV>
<DIV> </DIV>
<DIV>Ed A.</DIV>
<P> </P></FONT></BLOCKQUOTE></DIV>
<DIV></DIV>
<DIV>Ed</DIV>
<DIV>Wet sand it off with 2000 grit sand paper then polish with 3M #39007
Imperial Hand Glaze.</DIV>
<DIV>Before applying graphics clean the area with PPG # DX330 wax and grease
remover.</DIV>
<DIV>I usually wet sand my entire finish with 2000 grit paper being careful at
all sharp edges not to sand through the finish then polish out with the 3M hand
glaze and wax. No clear coat is necessary.</DIV>
<DIV>Buddy </DIV></FONT></BODY></HTML>