<br><font size=2 face="sans-serif">Mark</font>
<br>
<br><font size=2 face="sans-serif">&nbsp;Most of the time I have seen your
problem the actual fiber is not broken, but the resin is fractured. The
stinger is also a low stressed part. You do not need carbon fiber for the
repair, since you most likely have nothing finer than 3K plain weave, use
light weight thin fiberglass cloth.</font>
<br>
<br><font size=2 face="sans-serif">You will really want to clean this good.
&nbsp;Get a coffee can and fill it upwith 3-4 inches of acetone or methy-ethyl
ketone. Epoxy such as the one used on a high temp muffler is very chemical
resistant. Dip the entire back end up the muffler in the solvent and agitate
(in a vigorous circular motion-FZ). &nbsp;If the resin is fractured you
need to get the oil off of the fiber-so really get vigorous. This method
will leave no soap or other residue, and is far superior in cutting thru
the oil.</font>
<br>
<br><font size=2 face="sans-serif">Have one or two wraps of fine fiberlgass
cloth on the stinger and wet lay up with whatever epoxy you have. You might
want to pull a yarn from the weave and wrap the weave with hoop wraps to
keep it snug. &nbsp;The epoxy you have access to will not be as high temp
as the original, but it will work on the stinger.</font>
<br><font size=2 face="sans-serif"><br>
<br>
<br>
Gray Fowler<br>
Principal Chemical Engineer<br>
Composites Engineering</font>