<DIV id=RTEContent>Instead of nylon fishing line, try dental floss.<BR><BR><B><I>Dean Pappas <d.pappas@kodeos.com></I></B> wrote: <BLOCKQUOTE class=replbq style="PADDING-LEFT: 5px; MARGIN-LEFT: 5px; BORDER-LEFT: #1010ff 2px solid">Hi Guys.<BR>How about a nylon fishhing line loop that passes through all the connectors, between two of the wires in the connector, and around the RX?<BR>I've never done anything like this, but now that I think of it, I like the idea.<BR><BR>Dean<BR><BR>Dean Pappas<BR>Sr. Design Engineer<BR>Kodeos Communications<BR>111 Corporate Blvd.<BR>South Plainfield, N.J. 07080<BR>(908) 222-7817 phone<BR>(908) 222-2392 fax<BR>d.pappas@kodeos.com<BR><BR><BR>-----Original Message-----<BR>From: nsrca-discussion-bounces@lists.nsrca.org<BR>[mailto:nsrca-discussion-bounces@lists.nsrca.org]On Behalf Of Ken<BR>Thompson<BR>Sent: Thursday, December 15, 2005 5:56 AM<BR>To: NSRCA Mailing List<BR>Subject: Re: [NSRCA-discussion] securing servo wires<BR><BR><BR>David,<BR><BR>I
usually fold the wires down over the top of my receiver and secure them <BR>with a rubber band, around the receiver and wires, fairly snug.<BR>Make sure you leave enough wire so as not to bind the wire against the <BR>connector.<BR>Install as usual, sounds simple but it works for me.<BR><BR>Ken<BR>----- Original Message ----- <BR>From: "David Flynt" <DFLYNT@VERIZON.NET><BR>To: <NSRCA-DISCUSSION@LISTS.NSRCA.ORG><BR>Sent: Wednesday, December 14, 2005 10:51 PM<BR>Subject: [NSRCA-discussion] securing servo wires<BR><BR><BR>> Can anybody suggest a good way to help prevent servo wires from pulling <BR>> out<BR>> of a receiver? I have never paid attention to this, and never really had <BR>> a<BR>> problem except one time one of my elevator servo wires pulled loose. I <BR>> was<BR>> fortunate to have half an elevator remaining and enough control to land.<BR>> But now I only use a single elevator servo.<BR>><BR>> I typically use either JR r770 or r649
receivers.<BR>><BR>> Any ideas would be appreciated.<BR>><BR>> Thanks,<BR>><BR>> David Flynt<BR>><BR>> _______________________________________________<BR>> NSRCA-discussion mailing list<BR>> NSRCA-discussion@lists.nsrca.org<BR>> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion <BR><BR>_______________________________________________<BR>NSRCA-discussion mailing list<BR>NSRCA-discussion@lists.nsrca.org<BR>http://lists.nsrca.org/mailman/listinfo/nsrca-discussion<BR><BR>_______________________________________________<BR>NSRCA-discussion mailing list<BR>NSRCA-discussion@lists.nsrca.org<BR>http://lists.nsrca.org/mailman/listinfo/nsrca-discussion<BR></BLOCKQUOTE><BR></DIV>